Skip to content
Etobicoke Plumbing Company markEtobicokePlumbing Company Call a plumber · homes & businesses(365) 413-9789
Concrete manhole ring sitting in a puddle
A concrete manhole section waiting to be set.

Plumbing service

Tankless water heater installation

An on-demand unit lights its burner the moment a hot tap is opened and keeps going as long as you need. It frees floor space, but it needs a bigger gas supply, proper venting and service valves for regular descaling.

  • Gas demand: Much higher than a tank while firing
  • Venting: Usually PVC or polypropylene through the wall
  • Maintenance: Periodic descaling flush
  • Space saved: Unit hangs on the wall
Call now(365) 413-9789Tap to call. A plumber answers, not a call centre.

At a glance

Gas demand
Much higher than a tank while firing
Venting
Usually PVC or polypropylene through the wall
Maintenance
Periodic descaling flush
Space saved
Unit hangs on the wall

Is your house ready

The heater draws a lot of gas while it runs. If the existing gas line was sized for a furnace and a small tank, it may need upsizing from the meter. We check the meter rating and pipe run before recommending a model.

  • Venting must reach outside within the manufacturer’s limits, and condensing models must have somewhere to send their acidic condensate, which usually goes through a neutralizer.

Installation details that matter

We fit isolation valves with service ports so the heat exchanger can be descaled without cutting pipe. Lake Ontario water carries moderate hardness, so scale builds up over time, and a neglected exchanger loses efficiency.

  • The unit is mounted on a solid backing with room around it for service, and a dedicated outlet where required.

Living with it

Hot water takes a few seconds longer to reach the tap because the heater must fire first. A tiny draw, such as a dribble at the vanity, may fail to fire it. Most people adjust quickly.

  • Descaling at a regular interval keeps the unit efficient.
  • We can show you how or do it for you.

Signs to watch for

  • Tank needs replacing in a cramped utility room
  • Back-to-back showers run cold
  • Planning a basement suite
  • Want to remove a rental tank
  • Gas line already upgraded

How the job runs

  1. Check gas and venting

    We measure supply capacity and plan the vent route.

  2. Mount and pipe

    The heater is hung with service valves.

  3. Vent and drain

    Exhaust, intake and condensate lines installed.

  4. Commission

    Gas pressure, flow and temperature verified.

Related pages

Leak, clog or cold tank right now?

Phone the line and a plumber answers. We keep no forms or chat bots.

Bookings and emergency calls; ask for current hours. Long Branch to Humberwood, plus nearby west Toronto.

Tap to call(365) 413-9789
Call a plumber · (365) 413-9789